Installation and Servicing Instructions Alpha CombiMax Secondary Circulation Kit Suitable for use with the CombiMax 350 and 600 Unvented Hot Water Store CombiMax 350 - Secondary circulation kit - Part No. 1000461 CombiMax 600 - Secondary circulation kit - Part No. 1000466 For Technical help or for Service call ...
Serial No. A90600001. The kits include all pipework and components, i.e. thermostat, non-return valve and flow regulator, necessary to enable a secondary circulation loop to be connected directly to the CombiMax as shown in Fig. 1. Fig. 1 Alpha CombiMax Secondary Circulation...
Note: The vessel must be acceptable for use on mains water and have a pre-charge of 2.5 bar. A suitable vessel is available from Alpha Therm, Part No. 0001045. DHW CLOCK Sometimes it may be required to switch off the secondary circulation overnight to avoid unnecessary heat loss and operation of the appliance.
Page 5
F - Heating pressure relief valve (15 mm) G - Temperature/pressure expansion relief discharge pipe H - Drain point for DHW storage Note: Both Heating return and Cold water mains inlet valves contain serviceable filters. Fig. 3a - CombiMax 350 Alpha CombiMax Secondary Circulation...
CombiMax store has been fully recharged to its maximum temperature. The time to reheat the complete system, i.e. the CombiMax store plus the secondary circulation loop, will depend on the length of the secondary circulation loop. Alpha CombiMax Secondary Circulation...
Turn off the taps. Cover all electrical components beneath the CombiMax pump and then release the pump bleed screw until all the air has been vented. Retighten the screw. Alpha CombiMax Secondary Circulation...
Need help?
Do you have a question about the Alpha CombiMax and is the answer not in the manual?
Questions and answers