Using Your P35 Power Amplifier - Arcam A32 Handbook

Using your P35 power amplifier

POWER (AND POWER INDICATOR LIGHT)
Switches the unit on and off. The light indicates the status of the
amplifier.
When you switch your amplifier on, the light glows amber for a few
seconds, during which time the speakers are disconnected. The light
changes to green when the amplifier is ready for use.
means the amplifier is in standby mode.
The light may flash if a fault has occurred. You should unplug the
amplifier and leave it for a few minutes before reconnecting. If the
fault cannot be cleared, unplug your amplifier and contact your Arcam
dealer.
SP1 AND SP2
These buttons allow you to select and deselect the main (
secondary (
indicator light shows which set of speakers are currently selected.
A red light
NOTE: If both lights are out the amplifier will appear not to work,
as all speakers are switched off. If both are on, and low impedance
speakers are connected, overloads are more likely.
12
SP1
) sets of speakers attached to your amplifier. An
SP2
P35 POWER AMPLIFIER
SP2 POWER
) and
SP1