Recalibrating; Caring For Your Watch - Wenger Yacht Racer Instruction Manual

Recalibrating

It is possible that following a battery change, an incorrect activation, violent
impact, or exposure to a magnetic field, the countdown and/or racing timer
hands may fail to revert to their original positions. To reset the hands to their
zero positions please follow the below instructions. Note: Recalibration can only
be done after having stopped and reset Countdown Timer and Race Timer.
Hours/Seconds Timer (at 10:00 position)
1. Unscrew the crown and pull it out to Position 2.
2. After a minimum of one second, repeatedly press the Top Right Pusher until
the small red hand points directly to the "60". This is the original position for
the Hours/Seconds Timer.
3. Return the crown to Position 1 and screw it down to ensure water resistance.
Countdown Minutes/Race Timing Hand
1. Unscrew the crown and pull it out to Position 2.
2. After a minimum of one second, repeatedly press the Bottom Right Pusher
until the Countdown Minutes/Race Timing Hand points directly to 12 o'clock.
12
This is the original position for the Countdown Minutes/Race Timing Hand.
3. Return the crown to Position 1 and screw it down to ensure water resistance.

Caring for Your Watch

Even though your watch is water-resistant, it is not recommended that you wear it
in a hot shower, sauna or hot tub. We suggest sending your Wenger watch to
our Customer Service Center for battery replacement (please see procedure
under "Warranty Service"). Batteries should only be replaced by a professional
jeweler to maintain the watch's water-resistancy. If your watch has a bracelet,
we suggest you see a jeweler for any sizing adjustments.
13