Race Timer - Wenger Yacht Racer Instruction Manual

Race Timing
Race timing minutes are read on the watch dial (12 o'clock to 12 o'clock) and
the left subdial, not on the bezel.
Starting
Once the race start indicator sounds the race timer will begin. The Countdown
Minutes/Race Timing Hand will count minutes (it will jump every 12 seconds).
The Hours/Seconds Timer will count hours up to 4 revolutions or 96 hours.
Reading Elapsed Time
1. Press Bottom Right Pusher to display elapsed seconds on the Hours/Seconds
Timer. The hand will display seconds until it reaches "60" at which time it
will revert to reading hours
2. At any time during the display of race timing seconds (after Step 1 is initiat-
ed) you can switch to the race timing hours by pressing the Bottom Right
Pusher again.
10
Stopping and Restarting
If there is a reason to pause the race timer you can do so by pressing the Top
Right Pusher. You will hear one beep. Should you need to restart the timer,
press the Top Right Pusher again. You will hear two beeps.
Resetting the Race Timer
1. Press the Top Right Pusher. You will hear one beep.
2. Press the Bottom Right Pusher twice. The Countdown Minutes/Race Timing
Hand will reset to previously set countdown time.
11