Setting The Alarm; Using The Yacht Timing Functions; Countdown Timer - Wenger Yacht Racer Instruction Manual

3. Return the crown to the fully depressed Position 1, assuring the crown has
been fully screwed down.

Setting the Alarm

Important Note: If the alarm coincides with the countdown racing function, the
alarm will be cancelled.
1. Pull crown out to Position 2.
2. Rotate crown counterclockwise to set alarm hand (thin hand with blue arrow)
at desired alarm time.
3. Press bottom left pusher once to activate (2 beeps).
4. Return crown to Position 1, assuring the crown has been fully screwed down.
Alarm will sound when hour hand passes alarm hand.
5. When alarm sounds, press Bottom Left Pusher to deactivate.
6. At any time, you may press the Bottom Left Pusher to deactivate the alarm.
You will hear one beep.
Note: If alarm is not deactivated, it will sound once and then repeat in two
6
minutes for a duration of 15 seconds. If not deactivated alarm will sound again
in 12 hours.

Using the Yacht Timing Functions

The two key components of your watch are the Countdown Timer (times
remaining minutes to the start of a race) and the Race Timer (times the elapsed
time of the race).

Countdown Timer

It is first important to note that the countdown timer minutes are shown on the
bezel of the watch (10-6 in blue and 5-1 in red) not on the dial. The numbers
10 thru 1 (read clockwise) indicate the number of minutes remaining until the
start of a race.
Setting the Countdown Timer
1. Press Bottom Right Pusher for one second to enter the setting mode. You will
hear one beep.
Important Note: The watch will automatically exit the setting mode if left idle
for 3 seconds, at which time you will hear one beep.
(continued next page)
7