Board Installation; Unpacking; Installation Of The Motherboard - TYAN S1686D Manual

2.1 Unpacking

2.1.1. Item Checklist
The motherboard package should contain the following:
S1686D Motherboard
One IDE 40 pin cable
One 34 pin floppy cable
User's Manual
2.1.2. Precautionary measures before handling the motherboard
Since the motherboard contains sensitive electronic components which can
easily be damaged by static electricity, the motherboard should be left in its
original packaging until it is ready to be installed.
Before you open the carton of your computer, do the following:
1. Make sure that you stand on an Anti-static mattress. (Do not stand on a rug or
carpet.)
2. It is also strongly recommended that you wear an anti-static strap. (Anti-static
straps can be purchased at computer hardware stores.)
3. With the power supply plugged in and the system turned off, touch an unpainted
area of the system chassis before handling the motherboard or any component.
Remember to repeat the above steps whenever you handle the motherboard or its
components.
2.1.3. Proper handling of the motherboard
After opening the S1686D motherboard carton, remove the board by holding its
edges. Place it on a grounded anti-static surface with the component side up.
Inspect the board for damage. Do not touch the bottom of the board. (Note: DO
NOT APPLY POWER TO THE BOARD IF IT HAS BEEN DAMAGED!)

2.2. Installation of the Motherboard

You are now ready to install your motherboard. The mounting hole pattern of the
S1686D matches the ATX system board specifications. Please install the board
in the chassis designed for a standard ATX board form factor.
S1686D-001-01
Chapter 2: Board Installation
9