Table of Contents
Advertisement
25> Enter 1(via WWPN). Then, you will see the Boot device's settings window again. Confirm that
the top item on the list is "USED."
Adapter 01: S_ID:000001 PCI Bus #:07 PCI Device #:00
The Boot Device is: DID: 000000 WWPN:20000000 4C123456 LUN:00
List of Saved Boot Devices:
9. Used
DID:000000 WWPN:21000000 4C123456 LUN:00 Primary Boot
10. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
11. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
12. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
13. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
14. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
15. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
16. Unused
DID:000000 WWPN:00000000 00000000 LUN:00
Select a Boot Entry:_
Enter <x> to Exit
26> Press the <ESC> key to return to the following menu:
Adapter 01:
LPe1105-N I/O Base: 4000
Port Name: 10000000 C92B6B74
Topology: Auto Topology: Loop first (Default)
1. Configure Boot Devices
2. Configure This Adapter's Parameters
Enter a Selection: _
Enter <x> to Exit
<d> to Default Values
27> Select "2." Then, you will see the following settings window:
Adapter 01:
LPe1105-N I/O Base: 4000
Port Name: 10000000 C92B6B74
Topology: Auto Topology; Loop first (Default)
10. Enable or Disable BIOS
11.
Change Default ALPA of this adapter
12.
Change PLOGI Retry Timer (+Advanced Option+)
13.
Topology Selection (+Advanced Option+)
14.
Enable or Disable Spinup delay (+Advanced Option+)
15.
Auto Scan Setting (+Advanced Option+)
16.
Enable or Disable EDD 3.0 (+Advanced Option+)
17.
Enable or Disable Start Unit Command (+Advanced Option+)
18.
Enable or Disable Environment Variable (+Advanced Option+)
A. Auto Sector Format Select (+Advanced Option+)
Enter a Selection: _
Enter <x> to Exit
<Esc> to Previous Menu
PCI Bus #:07 PCI Device #:00
Firmware Version: ZS2.50A8
Node Name: 20000000 C92B6B74
<Esc> to Previous Menu
PCI Bus #:07 PCI Device #:00
Firmware Version: ZS2.50A8
Node Name: 20000000 C92B6B74
<Esc> to Previous Menu
- 40 -
Advertisement
Table of Contents
