NEC Express5800/1020Ba User Manual page 117

Peripheral Configuration Submenu
When you select "Peripheral Configuration" in the Advanced menu, the following submenu appears.
Advanced
Serial Port1 Configuration:
Serial Port1
System Serial Port Configuration:
System Serial Port:
PS/2 Mouse
F1 Help
Esc Exit
The table below describes each item in the Peripheral Configuration Submenu.
Item
Serial port 1 Configuration
Serial port 1
System Serial Port Configuration
System Serial Port
PS/2 Mouse
[ ]: Default setting
Note: About Serial Port
Serial Port 1 is a serial port (COM) in front of a CPU Blade to use as a standard serial port.
System Serial Port is a virtual serial port to display the OS redirected console to any devices within the
same network (Serial Over LAN). It is not the Standard serial port (COM) in front of the server.
PhoenixBIOS Setup Utility
Peripheral Configuration
[Enabled]
[3F8,IRQ4]
[Auto]
[2F8,IRQ3]
[Auto Detect]
^ v Select Item - / +
< > Select Menu Enter
Figure 3.5-4 Peripheral Configuration Submenu
Table 3.5-4 Peripheral Configuration Submenu
Option
[3F8,IRQ4]
3E8,IRQ4
2E8,IRQ4
Disable
Enable
[Auto Detect]
Change Values
Select Sub-Menu
Description
Displays the serial port 1 configuration.
Specifies the I/O address and interrupt line of the
Serial port 1.
Displays the system serial port configuration.
Specifies the I/O address and interrupt line of the
system serial port.
Enables / disables the PS/2 mouse.
3-15
Item Specific Help
Set the base I/O
address for Serial
Port 1.
F9 Setup Defaults
F10 Save and Exit