Advertisement
Preparing to Mount the IQ Profiler
1
Insert screwdriver into slot on bottom of unit to remove top of
housing
2
Remove the circuit board from the housing by gently pushing
outward on the PC board height index tab which is located on
the left edge of the housing.
3
Determine the wire entry point to be used. The housing
provides an entry point on the top of the enclosure. Any
unused screw hole recess may also be used for wire entry.
Determine which entry is most convenient and punch out or
remove the thin plastic section.
4
Feed wire through punch out hole.
Swivel mount
punch through
PC board height
index tab
Standard Corner
mount screw
IQ Profiler base detail
Wire entry
punch through
I
Q
nstall
uick
mounting pins (2)
I
Q
nstall
uick
corner mounting slot
Flat wall mount
screw holes
8
Advertisement
