Completing The Installation - NAPCO ADVANCED ADAPTIVE C-200AP Installation Instructions Manual

COMPLETING THE INSTALLATION

The jumper must be in either the
ALARM position or the LED position for
the alarm relay to operate. (If the 4-pulse
mode is selected, both the PIR and MW
Fig. 8. Zone-masking foil.
jumpers must be installed.) With the ALARM jumper (or PIR & MW numpers)
installed, the LED will indicate a condition that would cause an alarm if the
system were armed. To extinguish the Walk-Test LED after testing, place the
jumper across the LED terminals. In this position, the LED is disabled during
normal operation, but is enabled for diagnostic indications.
13