Initial Access To The Video Receiver; Check Network Settings; Add Password To Prevent Unauthorized Access - Vivotek RX7101 User Manual

Initial Access to the Video Receiver

Check Network Settings

The Video Receiver can be connected either before or immediately after software
installation onto the Local Area Network. The Administrator should complete the
network settings on the configuration page, including the correct subnet mask and IP
address of gateway and DNS. Ask your network administrator or Internet service
provider for the detail information. By default the Video Receiver requires the
Administrator to run installation every time it reboots. Please refer to "Network
settings" on the System Configuration page for details. If any setting is entered
incorrectly and cannot proceed to setting up the Video Receiver, restore the factory
settings following the steps in the "Troubleshooting" chapter of the Appendix.

Add Password to Prevent Unauthorized Access

The default Administrator's password is blank and the Video Receiver initially will not
ask for any password. The Administrator should immediately implement a new
password as a matter of prudent security practice. Once the Administrator's password
is saved, the Video Receiver will ask for the user's name and password before each
access. The user name for the Administrator is permanently assigned as "root". Once
the password is changed, the browser will display an authentication window to ask for
the new password. Once the password is set, there is no provision to recover
the Administrator's password. The only option is to restore to the original
factory default settings.
- 10 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532