Universal Remote Control UR3-SR3 Operating Manual page 7

digit for the code. Each digit is separated by a
one second interval of the LED being off.
Example : One blink, then three blinks, then eight blinks
indicates the code number 138.
*Note : Ten blinks indicates the number 0.
E. Programming a Second TV to the DVD Button
E. Programming a Second TV to the DVD Button
STEP1
Press the [DVD] button and the [OK/SEL] button
simultaneously for 10 seconds. The DVD LED will
turn on for 20 seconds. The next step must be
performed while the LED is on.
STEP2
Press the [TV] button.
STEP3
Point the remote control toward the TV and enter the
three-digit code for your TV from the TV codes table.
STEP4
Store the three-digit code by pressing the [DVD]
button. The device LED will blink twice to confirm
that the code has been stored.
F. Programming for Advanced Functions.
F. Programming for Advanced Functions.
In the CABLE device mode, the A,B,C,D and blank macro
buttons can be programmed to act as a 'Macro' or
Favorite Channel button. This allows you to program up to
five 2-digit channels, four 3-digit channels or three 4-digit
channels that can be accessed with on button press.
*Note : The A,B,C and D buttons are not programmable
if you have a Digital Cable Box made by Pace,
Pioneer or Scientific-Atlanta.
STEP1
Press the [CBL] button to select the CBL mode.
STEP2
Press the [MACRO] button and [OK/SEL] button
simultaneously for 10 seconds. The [CBL] button
will turn on for 20 seconds.
STEP3
Enter the the 2, 3 or 4-digit code for the channel you
want programmed first (for example, 007) using the
Number Pad, then press the [STOP] button. Then
enter the code for the next channel (for example,
050), then press the [STOP] button. Repeat this
5