Air Conditioner Controls; Remote Control - GE AJCH 08 ACB, AJCH 10 ACB, AJCH 10 DCB, AJCH 12 DCB, AJCQ 06 LCB, AJCQ 08 ACB, AJCQ 10 ACB, AJCQ 10 DCB, AJCQ 12 DCB, AJCS 06 LCB Owner's Manual

About the controls on the air conditioner—models with touch pads.
Appearance may vary.
Timer
On
Timer
Off
Controls

Remote Control

I
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
I
The remote control signal has a range of
4
up to 21 feet.
Sleep

Air Conditioner Controls

Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.
ON/STOP
Turns air conditioner on and off.
Display
MODE
On the remote control, use to set the air
conditioner to COOL or FAN mode.
On the air conditioner controls, use to set
COOL or FAN mode at HIGH, MED or LOW
fan speed. Indicator lights on the air
conditioner controls will show the mode
and fan speed selected.
L
TEMP Increase /Decrease
Use to set temperature when in COOL
mode.
Fan Speeds (Remote control only)
Use to set the fan speed at LOW, MED or
HIGH.
TIMER
ON—When the air conditioner is off, it
can be set to automatically turn on in half
an hour to 24 hours at its previous setting.
Each touch will set the time in half hours
up to 10 and then in hours up to 24.
Cool
Fan
High
Med
Low
On
To cancel (CL) the On Timer press the
ON pad again.
OFF—When the air conditioner is on, it
can be set to automatically turn off in half
an hour to 24 hours. Each touch will set
the time in half hours up to 10 and then
in hours up to 24.
To cancel (CL) the Off Timer press the
OFF pad again.
To cancel the timer, press the ON or OFF
pads until the display time disappears.
SLEEP
M
Pads Press to set the air conditioner to run for
8 hours before it automatically returns to
the previous setting.
When the sleep timer is set, the set
temperature will automatically increase
2°F after the second hour then 1°F each
hour over the next two hours.
To cancel the sleep mode, press the MODE
pad or the SLEEP pad a second time.
Remote Control Signal Receiver
I
Make sure nothing is between the air
conditioner and the remote control that
could block the signal.
I
Make sure batteries are fresh and installed
correctly—see the Care and Cleaning section.
Remote Control
When the air conditioner is turned on, it will
automatically start in the setting last used.