ProForm 310 Cx Bike Manual page 7

3. Slide the Shield Cover (5) upward onto the
Upright (4).
Have a second person hold the Shield Cover (5)
around the Upright (4) until you complete step 4.
Tip: Avoid pinching the wires inside the
Frame (1). Slide the Upright (4) onto the Frame.
Attach the Upright (4) with five M8 x 16mm
Screws (60) and five M8 Split Washers (61).
4. Locate the wire tie inside the Upright (4). Then,
locate the Wire Harness (89) and the Frame
Pulse Wire (91) inside the Frame (1).
Tie the lower end of the wire tie to the ends of
the Wire Harness (89) and the Frame Pulse Wire
(91).
Then, pull the other end of the wire tie upward
until the Wire Harness (89) and the Frame Pulse
Wire (91) are routed completely through the
Upright (4).
Then, slide the Shield Cover (5) downward and
press it onto the Right and Left Front Shields
(21, 22).
3
61
60
60
4
Wire Tie
22
7
Avoid pinching
the wires
5
4
61
60
61
1
5
Wire
91
Tie
89
4
1
21