ProForm 1550cwi User Manual page 16

you to increase or decrease your pace to bring
your heart rate closer to the target heart rate.
When the right indicator changes in height,
increase or decrease your pace so that both indi-
cators are at the same height. If your pace is
slower than the current target pace, the increase
arrow will appear in the display; if your pace is
faster than the target pace, the decrease arrow
will appear. Important: The target pace is
intended only to provide a goal. Your actual
pace may be slower than the target pace,
especially during the first few months of your
exercise program. Make sure to pedal at a
pace that is comfortable for you.
If you continue pedalling after the program is
completed, the display will continue to show your
exercise feedback.
Follow your progress with the feedback
6
modes.
See step 4 on page 13.
When you are finished exercising, the console
7
will automatically turn off.
See step 6 on page 13.
HOW TO USE THE WATTS PROGRAM
The watts program is designed to keep your power
output near a target watts level that you set. Follow
the steps below to use the watts program.
Turn on the console.
1
See step 1 on page 13.
Select the watts program.
2
Each time the
console is turned
on, the manual
mode will be
selected. To
select the watts
program, press
the Program but-
ton repeatedly until the number 8 appears in the
upper right corner of the display.
Enter a target watts level.
3
When the watts program is selected, the watts
mode indicator and a target watts level of 20 will
appear in the display (see the drawing above).
Press the + or – button repeatedly to change the
target watts level, if desired. The target watts
level can be from 20 to 250.
Start the program.
4
To start the program, simply begin pedalling. The
watts program consists of forty, one-minute peri-
ods. The same target watts level is programmed
for all periods.
During the program, the resistance of the exer-
cise cycle may periodically change to keep your
power output near the target watts level that you
set. Note: If the current resistance level is too
high or too low, press the + or – buttons.
Pressing the + and – buttons will change the tar-
get watts setting.
16