Maintenance And Troubleshooting - ProForm 1050 Bike Manual

MAINTENANCE AND TROUBLESHOOTING

HOW TO MAINTAIN THE EXERCISE BIKE
Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
CONSOLE TROUBLESHOOTING
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, the drive belt
may need to be adjusted.
See the EXPLODED DRAWING on page 27 to iden-
tify the parts mentioned below.
To adjust the Drive Belt (30), first unplug the power
adapter.
Use a flat screwdriver and remove the Upper Shield
(10) and the right Shield Cover (13).
Next, remove the #8 x 32 x 13mm Screw (81) from the
Right Shield (11).
Then, use a socket set to remove the two 1/4" Flange
Nuts (21) from the Right Shield (11).
Remove the two #8 x 1/2" Screws (61) on the right side
of the Electronics Shield (82).
Then, gently move the Right Shield (11) away from the
exercise bike.
Locate the Idler Pulley (37). Loosen the 3/8" Jam Nut
(71). Then, tighten the Idler Adjustment Screw (39) until
the Drive Belt (30) is tight.
When the Drive Belt (30) is tight, tighten the 3/8" Jam
Nut (71).
Reattach the Right Shield (11) with the #8 x 1/2"
Screws (61), the 1/4" Flange Nuts (21), and the #8 x 32
x 13mm Screw (81). Then, reattach the Upper Shield
(10) and the right Shield Cover (13).
24