Care And Cleaning; Air Filters; Base Pan; Exhaust Coils - GE 49-7419-2 Owner's Manual And Installation Instructions

Care and cleaning.

Turn the Zoneline off and disconnect the power supply before cleaning.
Indoor/Outdoor Coils
The exhaust coils on the Zoneline should be
checked regularly. If they are clogged with dirt or
soot, they may be professionally steam cleaned by
your GE service center. You will need to remove
the unit from the case to inspect the coils
because the dirt build-up occurs on the
exhaust side.
Drain
Clean the drain system regularly to
prevent clogging.

Base Pan

In some installations, dirt or other debris may be
blown into the unit from the outside and settle in
the base pan (the bottom of the unit).

Air Filters

To maintain optimum performance, change the filter at least every 30 days.
The most important thing you can do to
maintain the Zoneline is to change the filter at
least every 30 days. Dirty filters reduce cooling,
heating and air flow.
Changing the filter will: Decrease cost of operation,
save energy, prevent clogged heat exchanger
coils and reduce the risk of premature
component failure.
CAUTION:
Zoneline without the filter in place. If a filter
becomes torn or damaged, it should be replaced
immediately.
Operating without the filter in place or with a
damaged filter will allow dirt and dust to reach
the indoor coil and reduce the cooling, heating,
airflow and efficiency of the unit.
Replacement filters should be purchased from
your local retailer where air conditioner and
furnace accessories are sold.
Filter size required is 20" x 20" x 1".
Do not operate the
Have the coils cleaned regularly.
In some areas of the United States, a "gel-like"
substance may be present in the base pan.
Check it periodically and clean, if necessary.
To remove
and replace
the filter:
Filter
Return air grille
GEAppliances.com
Outdoor coils
Remove filter
Unit-mounted filter
Filter
Access-panel with
9
return air grille