GCC Technologies 16 User Manual page 159

7-12 GCC Elite Color 16 Series User's Guide
Interface Menu
Submenus
Network 1 Setup
Available Settings (Bold is Default)
Interpreter:
Auto Switch
PCL
PostScript 3
Format:
Raw
Normal
Binary
Network Channel:
Netware On
DEC LAT On
AppleTalk On
TCP/IP On
Network Address:
(factory set)
IP Address:
(user-specified)
Subnet Mask:
(user-specified)
Default Router:
(user-specified)
LPD Banner:
On
Off
DHCP:
On
Off
Netware Frame:
Auto-Sense,
802.3,
Ethernet II,
802.2 SNAP,
802.2,
Delay Out Close:
Off
On
Description
This submenu allows you to set up the Ethernet
Network interface.
Interpreter determines whether the Ethernet port
will accept only PCL jobs, only PostScript jobs, or
both (Auto Switch).
Format sets the default data format mode for the
Ethernet port.
Network Channel sets the individual network
protocols on or off.
Network Address displays the factory-set network
address (informational only, cannot be changed).
IP Address allows an IP address to be assigned to
the printer.
Subnet Mask allows a subnet mask to be assigned
to the printer.
Default Router allows a default network router
address to be assigned to the printer.
LPD Banner controls whether the printer sends
banner information along with LPD print jobs.
DHCP sets whether the printer will obtain its IP
address from a DHCP server or not.
Netware Frame sets the Netware frame type.
Delay Out Close determines whether the printer
immediately closes communication with the
computer after the job is transmitted, or waits until
the job is processed to do so.