Advertisement
Recorder modes
ScopeRecord
Roll Mode
™
Dual or multiple input waveform storage mode, using deep memory
Source and display
Bandwidth
Memory depth
Min/max values
Recording modes
Stop-on-trigger
Horizontal scale
Zoom
Memory
ScopeRecord
Roll mode sample rate and recording timespan
™
Time base range
Recorded timespan
Time/division in 'view all' mode
Glitch capture
Sample rate
Resolution
Trendplot
Recording
™
Multiple channel electronic paperless recorder. Graphically plots, displays and stores results of up to four automatic scope measurements or a
DMM-reading over time.
Source and display
Memory depth
Ranges
Recorded time span
Recording mode
Measurement speed
Horizontal scale
Zoom
Memory
Cursor measurements—all recorder modes
Source
Dual vertical lines
Shop for Fluke products online at:
190-062
190-102
Input A, Input B, Dual.
All channels sampled simultaneously.
20 MHz or 20 kHz, user selectable
30,000 data points, each holding min/max pair of information
Min/max values are created at samples that are measured at high sample rate
ensuring capture and display of glitches
Single sweep, continuous roll,
Start-on-Trigger (through external),
Stop-on-Trigger (through external)
ScopeRecord mode can be stopped by an individual trigger event, or by an interruption
of a repetitive trigger signal, through any input channel (through External on 190-XX2 Series)
Time from start, time of day
Ranges from full record overview to zoom in up to sample level, at any record length
Two multiple input ScopeRecord waveforms can be saved internally for later recall and analysis
Direct storage on external flash memory drive through USB host port
5 ms/div ~ 2 min/div
6 sec ~ 48 hr
0.5 s/div ~ 4 h/div
8 ns
125 MS/s
200 μsec ~ 4.8 sec
Any combination of scope measurements, made on any of the input channels, or DMM reading
(2-channel instruments)
18,000 points (sets) per measurement. Each recorded sample point contains a minimum, a maximum and an
average value, plus a date- and timestamp.
Normal view: 5 s/div to 30 min/div
In view-all mode: 5 min/div to 48 hr/div (overview of total record)
Up to 22 days, with a resolution of 102 seconds
Continuous recording, starting at 5 s/div with automatic record compression
3 automatic measurements per second or more
Time from start, time of day
Up to 64x zoom-out for full record overview, up to 10x zoom-in for maximum detail
Two multiple input TrendPlot records can be saved internally for later recall and analysis
Direct storage on external flash memory drive through USB host port
Any waveform trace in any waveform display mode (Scope, ScopeRecord or TrendPlot)
Cursors may be used to identify Min, Max or Average value of any datapoint in a record,
with time between cursors, time from start or absolute time.
MyFlukeStore
www.
190-202
190-502
.com
ScopeMeter 190 Series II
190-104
190-204
Any combination of inputs,
up to 4 channels. All channels
sampled simultaneously.
Single sweep, continuous roll,
Start-on-Trigger (through any
channel), Stop-on-Trigger (through
any channel)
1.877.766.5412
Fluke Corporation 5
Advertisement
