The Security Menu; The Exit Menu - Hitachi GD8000 User Manual

GD8000 User Guide GD8000 User Guide GD8000 User Guide

The Security Menu

Field
Change Supervisor
Password
Change User Password Enter New Password
Clear User Password
Password Check
CAUTION
Incorrect settings can cause your system to malfunction. To correct mistakes, return to Setup and restore the Setup
Defaults by pressing F9.

The Exit Menu

You use the exit menu to leave the BIOS Setup Utility.
Field
Save Changes and Exit
Discard Changes and Exit
Discard Changes
Load Optimal Defaults
General Dynamics Itronix | 72-0137-003
Setting Description
Enter New Password Install or Change the Supervisor password. This field must be set before a
user level password can be set. You will be prompted to set and then verify a
new password. Type in six or fewer keystrokes. If you make an error, press
ESC
Install or Change the User password.
Clear User Password? Immediately clears the User password. This option is only available when a
Ok
user password has been set.
Cancel
Setup This option is only available when a password has been set.
Always Setup: requires a password when entering the setup utility.
Always: requires a password during boot and when entering the setup utility.
Setting
O
k
Cancel
O
k
Cancel
O
k
Cancel
O
k
Cancel
to start over.
Description
Exit system setup after saving the changes. The
this operation.
Exit system setup without saving any changes. The
used for this operation.
Discards changes done so far to any of the setup questions. The
can be used for this operation.
Load Optimal Default values for all the setup questions. The
be used for this operation.
Customizing Your BIOS
F10 key can be used for
ESC key can be
F7 key
F9 key can