Table of Contents
Advertisement
GD8000 User Guide
Display
The GD8000 features a 13.3-inch, XGA, outdoor-viewable,
color display with an optional integrated touch screen. You
can start programs and input data on the touch screen using
an approved pen (stylus) that comes with the computer. The
Colorvue™ Transmissive display technology uses a built-in
backlight for easy reading in most ambient light conditions.
DynaVue
display technology provides improved outdoor
®
visibility and even works well in sunlight.
CAUTION
To avoid damaging the display, do not slam it
when you close it. Also, do not place any object on top of the
computer when the display is closed.
Install the Stylus Tether
1.
Insert one tether loop through one of the holes on the end of
the stylus, then pull it back through the adjacent hole.
NOTE
The holes in the stylus are notched on one side and
smooth on the other. Feed the tether through the smooth side
first, so that it lies inside the notch when finished.
2.
Insert the free end of the tether through the loop and pull the
slack back through the loop to secure the stylus.
3.
Repeat these steps with the other end of the tether to attach it
to one of the tether slots on the front on your computer.
Calibrate the (optional) Touch Screen
1.
Press down on one side of the stylus to remove it from its slot
below the touchpad.
2.
Start
From the
menu select
Configure Utility
.
3.
On the eGalaxTouch dialogue box, select the
Linearization Button
then click the
calibration
.
4.
Use an approved stylus and follow the instructions provided to
complete touch screen calibration.
5.
OK
Click
to save the new settings and click
using your computer.
Adjusting Display Brightness
FN + F6
Press
to decrease display brightness
„ „
FN + F7
Press
to increase display brightness
„ „
General Dynamics Itronix | 72-0137-003
All Programs, eGalaxTouch,
Tools
tab and
9 pt
. This will initiate
OK
again to begin
Getting Familiar With Your Computer
Press down to remove stylus
smooth side
Adjusting Display Resolution
Windows XP:
1.
Right click on the desktop.
2.
Properties
Select
and then select the
box indicates the monitor screen resolution.
3.
Use the slide bar to adjust the resolution. Normally, you should
use the resolution suggested for the display or monitor.
Windows Vista and Windows 7:
1. Click on the Start button and then on Control Panel.
2. Under Appearance and Personalization, click on Adjust
Screen Resolution.
3. Use the slide bar to adjust the resolution.
NOTE
Using a lower resolution than the screen was designed
for will reduce the area of the display. You can stretch low
resolution displays to full screen size by enabling Screen
Expansion on the Main Menu of the
However, the stretching may cause distortion, especially to
fonts. Higher resolution modes may be used as long as the
monitor supports them.
Settings
tab. The dialog
BIOS Setup
Utility.
Advertisement
Table of Contents
Troubleshooting
