Configuration; Connect To A Wireless Network - D-Link DSM-210 - Wireless Internet Photo Frame User Manual

Configuration

This section will show you how to configure your new D-Link Wireless Internet Photo Frame. If you are not going to
connect your DSM-210 to a network or to the Internet, and simply want to display pictures from the internal memory,
memory card, and/or from an USB thumb drive, then skip to page 16.

Connect to a Wireless Network

For the quickest and easiest installation, it is highly recommended that both DHCP and SSID Broadcast are enabled on
your home network. Most networks have DHCP and SSID broadcast enabled to allow new devices to find the wireless
network and connect automatically. If not, then you will need to manually enter the network settings and/or the SSID
of your wireless network (skip to page 15).
Note: DHCP (Dynamic Host Configuration Protocol) allows network settings required by the DSM-210 to be set automatically.
You may also use the WPS button for installation. However, it can only be
used if your router or access point supports Wi-Fi Protected Setup (WPS).
Skip to page 12 for WPS installation.
To bring up a list of available wireless networks, use the arrow keys on the
remote control and navigate to the Setup icon. Select Wireless Settings
and press OK.
A list of available networks will appear in the left pane. Select your wireless
network and press OK.
D-Lnk DSM-210 User Manual 10