Connect To A Wired Network - D-Link DSM-210 - Wireless Internet Photo Frame User Manual

Connect to a Wired Network

By default, the picture frame is set to wireless mode. To connect to your network using an Ethernet cable, you must set
the picture frame to wired mode.
Once the DSM-210 is powered on, use the remote control
to navigate to the Setup icon.
Select Switch to Wired Mode. The picture frame will
reboot.
Once rebooted, navigate to the Setup icon and select
Network Settings to configure the IP settings (see next
page).
D-Lnk DSM-210 User Manual 1