Configuration; Connect To A Wireless Network - D-Link DSM-210 User Manual

Configuration

This section will show you how to configure your new D-Link Wireless Internet Photo Frame. If you are not going to
connect your DSM-210 to a network or to the Internet, and simply want to display pictures from the internal memory,
memory card, and/or from an USB thumb drive, then skip to page 16.

Connect to a Wireless Network

For the quickest and easiest installation, it is highly recommended that both DHCP and SSID Broadcast are enabled on
your home network. If not, then you will need to manually enter the network settings and/or the SSID of your wireless
network (refer to page 15). Most networks have DHCP and SSID broadcast enabled to allow new devices to find the
wireless network and connect automatically.
DHCP (Dynamic Host Configuration Protocol) allows network settings required
by the DSM-210 to be set automatically.
If your router or access point supports Wi-Fi Protected Setup (WPS), skip
to page 12.
To bring up a list of available wireless networks, use the arrow keys on the
remote control and navigate to the Setup icon. Select Wireless Settings
and press Enter.
A list of available networks will appear in the left pane. Select your wireless
network and press Enter.
D-Lnk DSM-210 User Manual 10