Gateway GT5448E - GT - 2 GB RAM Reference Manual page 44

6
7
8
9
10
38
CHAPTER 4: Upgrading Your Computer
Remove the two drive retention screws, then slide the
drive forward and out of the drive bay.
Slide the new drive into the drive bay, line up the screw
holes on the drive bay with the screw holes on the drive,
then replace the two drive retention screws.
Reconnect the drive cables using your notes from
Step 4, or according to the manufacturer's instructions.
Replace the front bezel by following the instructions in
"Replacing the front bezel" on page
Replace the side panel by following the instructions in
"Replacing the side panel" on page
Drive retention screws
Drive retention screws
32.
33.