Programming your 2-way remote control
To enter programming mode:
Press and hold the
trol until one long beep sounds. You can now customize the remote's
response feedback. If no buttons are pressed within 5 seconds, pro-
gramming mode is exited; the remote sounds 2 beeps.
Beeps and Vibration, On/Off
Press
to select beep/vibration On or Off, or one of the below
settings.
Beeps/Vibrate
Beeps only
Vibrate only
Beep & Vibrate
No Beep & No
Vibrate
*Displays during programming
Illumination On/Off
Press
to select LCD backlight illumination On/Off. The LCD back-
light will illuminate when a remote button is pressed, or an alarm status
page is received.
LCD backlight settings
On
Off
10
button located on the back of the remote con-
Response
1 beep
1 vibrate
1 beep & 1 vibrate
1 long beep
Programming
1 beep backlight On
2 beeps backlight Off
Icon*
&
© 2012 Directed. All rights reserved.