Edimax EW-7303HPn V2 Specifications page 2

N150 High Power Outdoor Wireless Access Point/Range
Features
• Complies with IEEE 802.11b/g/n standards
• Supports 2.4000 to 2.4835GHz frequency bands
• Network data rates up to 150Mbps
• Auto rate fallback in cases of interference
• Features WDS (Wireless Distribution System) repeater mode
• Supports WDS with AP mode
• Supports WEP, WPA, WPA2, AE2, 802.1x authentication
• Features WPS (Wi-Fi Protected Setup)
• Web-based configuration interface
• Firmware upgradable
• Features LNA (Low Noise Amplifier)
• Supports gateway, bridge and WISP operation modes
• Supports VPN pass-through for PPTP, IPsec and L2TP connections
Specifications
Product
Frequency Bands
Flash
RAM
LAN Port
Antenna
Output Power
Power
Dimensions
Weight
Temperature
Humidity
Certification
*Maximum performance, actual data rates and coverage may vary depending on network conditions and environmental factors. Stated ranges
are based on independent test results and are not guaranteed. Long range coverage requires an additional high power access point to receive
the wireless signal from the EW-7303HPn V2 – coverage range from an EW-7303HPn directly to a computer/wireless device is significantly less.
Copyright © 2012 Edimax Technology Co. Ltd. All rights reserved. Product specifications and design are subject to change without notice.
Extender with Built-in 12dBi Antenna
150Mbps Wireless High Power Outdoor Range
Extender/Access Point
2.4 - 2.484GHz
4MB NOR Flash
32MB SDRAM
10/100M Passive PoE Port x 1
Internal: 12dBi directional panel antenna
External (optional): SMA connector
11n: 22±1dBm, -89dBm
11g: 26±1dBm, -91dBm
11b: 27±1dBm, -93dBm
12V DC, 1A
225 (H) x 77 (W) x 59 (D) mm
250g (8.82oz)
Operating: -20 to 70°C
Operating: 10-90% (non-condensing)
Storage: Max. 95% (non-condensing)
FCC
www.edimax.com
EW-7303HPn V2