Using A Dynamic Dns Service - Gateway WBR-100 Installation Manual

3
To enable the selected virtual server, click to select the
in the Properties section, then click the arrow to open the
and click the computer you want to act as the server. Default settings for
Internal Port No.
you have made changes to a pre-defined server, click
to save the changes.
4
To configure a new (not pre-defined) virtual server, type the name in the
box to the right of
and click the computer you want to act as the server. Click the arrow to
open the
the settings for
(normally the same as the Internal Port number). Click
Port No
to add the new server to the Servers list, or
Server
your entries.
5
Close the window to return to the Advanced Features/Configuration window.

Using a dynamic DNS service

Dynamic DNS is an external service provided by a third party. To set up
Dynamic DNS you must register with this third party provider and obtain a
user name, a password, and a domain name.
Dynamic DNS lets you use a domain name (which will not change) instead of
an Internet IP address (which may change each time you connect to your ISP's
server) to connect to your virtual servers.
and
External Port No.
, then click the arrow to open the
Enable
list, then click the type of protocol the server uses. Type
Protocol
Internal Port No
www.gateway.com
are shown for pre-defined servers. If
(based on the server software) and
Advanced features
check box
Enable
list
PC (Server)
Update Selected Server
list
PC (Server)
External
Add as new
to remove
Clear Form
43