Mackie MDR24/96 Operation Manual page 16

Installing either remote is as simple as plugging in a telephone. Connect one end
of the cable (supplied with the Remote) to the REMOTE jack on MDR24/96 rear
panel, and the other end to the TO HDR REMOTE JACK jack on the Remote 24,
or to the TO HDR jack on the Remote 48. It's OK to plug or unplug either Remote
with the MDR24/96 powered on. However, if you plug the Remote 48 into the
MDR24/96 while both are powered on, you must power cycle the Remote 48 to
reset the connection.
For hands-free do-it-yourself punches and other frequently-used functions like
Play/Stop, Punch In/Out, and Take Select, connect the cable of a momentary,
normally open footswitch to the FOOT SWITCH 1/4" TS jack on the rear panel of
the MDR24/96, the Remote 24, or Remote 48. If you have a Remote installed you
can connect two foot switches, one to the MDR24/96 and one to the Remote. Each
footswitch functions independently of the other. Footswitch functionality is
assigned in the front panel System menu.
OK, NOW you can turn it on. Assuming you have already connected the MDR24/96
to your console, power up the MDR24/96 first, then the outboard equipment and
console, and finally the power amplifiers or powered monitors. Audio equipment
tends to generate unexpected clicks and pops when you power it up, so by
powering up your monitoring system last, you'll save your speakers and your ears.
Before you read the next section, take a quick, self-guided tour of the front panel
display and controls to get a sense of where they are.
TO HDR/MDR
REMOTE 24 FOOT SW
REMOTE JACK
WARNING
DO NOT PLUG INTO
ETHERNET
Remote
connection
Footswitch
ANALOG I/O ANALOG I/O ANALOG I/O
M
TAPE IN/OUTS
Back panel of the
Mackie Remote 24
Footswitch
Ethernet Jack