Sony SS-HA1 Operating Instructions

Speaker System
Operating Instructions
Mode d'emploi
Manual de instrucciones
SS-HA1/HA3
English
Owner's Record
The model and serial numbers are located on the
bottom of the unit. Record the serial numbers in the
space provided below. Refer to them whenever you
call upon your Sony dealer regarding this product.
Model No.
Serial No.
Features
The forward-facing and upward-facing super
tweeter configuration achieves a
multidirectional listening experience. Uniquely
shaped front panels with boldly cut edges
also help prevent sound diffraction. That way,
high-quality sound from sound sources or
CDs can be enjoyed in wider area than with
conventional speakers.
Connections
Before connecting, turn off the amplifier to
ˎ ˎ
avoid damaging the speaker system.
When turning the amplifier or program
ˎ ˎ
source power on/off, reduce the sound level
on the amplifier to minimum.
When bass sound is missing or the sound
ˎ ˎ
output position of musical instruments is
not distinct, make sure the +/– terminals of
speaker cords are connected properly.
Precautions
Avoid driving the speaker system
ˎ ˎ
continuously with a wattage exceeding the
maximum input power of each speaker.
Do not place anything on the speakers.
ˎ ˎ
Do not attempt to open the enclosure or
ˎ ˎ
remove speaker units. There are no
user-serviceable parts inside.
Connection/Raccordement/Conexión
4-475-026-11(3)
Right
Droit
Derecho
Speaker cord (supplied)
Cordon d'enceinte (fourni)
Cable del altavoz (suministrado)
Output power of your receiver or amplifier must not be over the maximum input power of
ˎ ˎ
the speaker system, and an appropriate volume level to prevent sound distortion must be
kept. See "Specifications" for the maximum input power.
La puissance de sortie de votre récepteur ou de votre amplificateur ne pas doit être
ˎ ˎ
supérieure à la puissance d'entrée maximum du système d'enceintes, et vous devez
maintenir le volume à un niveau approprié afin d'éviter la distorsion. Voir la section
« Spécifications » pour connaître la puissance d'entrée maximum.
La potencia de salida del receptor o el amplificador no debe sobrepasar la potencia
ˎ ˎ
máxima de entrada del sistema de altavoces, por lo que, para evitar la distorsión del
sonido, se debe ajustar un volumen apropiado. Puede consultar la potencia máxima de
entrada en "Especificaciones".
© 2013 Sony Corporation
Keep recorded tapes, watches, personal
ˎ ˎ
credit cards, and hard disk drives using
magnetic coding away from the speaker
system.
The speaker system has been tuned without
ˎ ˎ
the grill on. Remove the grill before using
the speaker system.
Cleaning and maintenance
To avoid damaging the enclosure, do not
ˎ ˎ
use thinner, alcohol, benzene, etc.
To keep a good gloss on the enclosure, dust
ˎ ˎ
it first using a soft cloth, a brush, or a feather
duster and then polish it using a dry
cleaning cloth (never use a scrubbing brush
or a sponge).
Wipe the surface gently. For fingerprints or
ˎ ˎ
oil stains, etc., breathe on the surface and
wipe it off with a cleaning cloth.
If the enclosure becomes extremely dirty,
ˎ ˎ
wipe the enclosure using a soft cloth slightly
moistened with a soap and water mix.
Be careful not to scratch the surface of the
ˎ ˎ
enclosure.
Wipe dust and other dirt from the super
ˎ ˎ
tweeter (top panel) using a blower brush or
soft brush.
Speaker Placement
Please note that room acoustics can often
ˎ ˎ
produce large difference in the sound for
small changes in speaker placement.
Place the speaker system against a hard
ē ˎ
wall with its back about 20 cm away from
a wall.
Place the right and left speakers in a
ē ˎ
similar acoustic environment.
Do not place the speaker system in the
ˎ ˎ
following places:
Anywhere that is extremely hot or under
ē ˎ
direct sunlight
+ terminal (red)
Borne + (rouge)
Terminal + (rojo)
– terminal (black)
Borne – (noire)
Terminal – (negro)
Printed in China
Anywhere that is dusty
ē ˎ
Anywhere that is extremely humid
ē ˎ
Near a player
ē ˎ
In a cabinet, especially one above your line
ē ˎ
of sight

Specifications

SS-HA1
Speaker system
Loud speaker units
Enclosure type
Rated impedance
Maximum input power 100 watts
Sensitivity level
Effective Frequency Range 48 Hz - 50 kHz
Dimensions (w/h/d)
Mass
Supplied accessories
SS-HA3
Speaker system
Loud speaker units
Enclosure type
Rated impedance
Maximum input power 70 watts
Sensitivity level
Frequency range
Dimensions (w/h/d)
Mass
Supplied accessories
Design and specifications are subject to change
without notice.
Left
Gauche
Izquierdo
Amplifier
Amplificateur
Amplificador
Speaker cord (supplied)
Cordon d'enceinte (fourni)
Cable del altavoz (suministrado)
3 way, 4 drivers speaker
system
Woofer: 13 cm (5 3/4 in.),
cone type (1)
Tweeter: 2.5 cm (1 in.), soft
dome type (1)
Super tweeter: 1.9 cm
(3/4 in.), soft dome type (2)
Bass reflex
4 ohms
86 dB (2.83 V, 1 m)
Approx. 185 mm × 312 mm ×
312 mm
(7 3/8 in. × 12 3/8 in. × 12 3/8 in.)
Approx. 4.8 kg (10 lb. 9 oz.)
Speaker cords (2)
Operating Instructions (1)
2 way, 3 drivers speaker
system
Woofer: 10 cm (4 in.), cone
type (1)
Super tweeter: 1.9 cm
(3/4 in.), soft dome type (2)
Bass reflex
4 ohms
83 dB (2.83 V, 1 m)
55 Hz - 50 kHz
Approx. 150 mm × 231 mm ×
232 mm
(6 in. × 9 1/8 in. × 9 1/8 in.)
Approx. 3.1 kg (6 lb. 13 oz.)
Speaker cords (2)
Operating Instructions (1)