Final Installation Checklist - Samsung DV50F9A8EVW/A2 User Manual

CONNECTING THE INLET HOSE
M ETHOD1
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
1. If space permits, attach the brass female end of the "Y" connector to the cold water faucet.
2. Turn the cold water faucet off.
3. Attach the straight end of long hose to "Y' connector.
4. Using pliers, tighten the coupling with an additional two-thirds turn.
Do not overtighten, as it may damage the coupling. ,_L, l
5. Attach angled end of long hoses to fill the valve at the
bottom of the dryer's rear frame. Screw on coupling by hand
until it is seated on fill valve connector.
6. Using pliers, tighten the coupling with an additional two-thirds turn.
[_Do not overtighten, as it may damage the coupling.
7. Check that the water faucets are on.
8. Check for leaks around "Y" connector, faucets and hoses.
M ETHOD2
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
1. If "Y" connector cannot be attached directly to the cold water
faucet, the short hose must be used.
2. Turn the cold water faucet off.
3. Attach short inlet hose to cold water faucet.
Screw on coupling by hand until it is seated on the faucet.
4. Using pliers, tighten the coupling with an additional
two-thirds turn.
Do not overtighten, as it may damage the coupling.
5. Attach 'Y" connector to brass male end of small hose.
Screw on coupling by hand until it is seated on connector.
6. Using pliers, tighten the coupling with an additional two-thirds turn.
Do not overtighten, as it may damage the coupling.
7. Attach angled end of long hoses to the fill valve at the bottom of the dryer rear frame. Screw on
coupling by hand until it is seated on fill valve connector.
8. Using pliers, tighten the coupling with an additional two-thirds turn.
[_Do not overtighten, as may damage coupling.
it the
9. Check that the water faucets are on.
10. Check for leaks around "Y" connector, faucets and hoses.
Fi NAL INSTALLATION OH ECKLiST
[] The dryer is plugged into an electrical outlet and grounded properly.
[] The exhaust ductwork is hooked up and the joints are taped.
[] You have used rigid or stiff-walled flexible metal duct material, not plastic flexible duct.
[] The dryer is level and is sitting firmly on the floor.
[] For gas models: The gas is turned on and there are no gas leaks.
[] Start your dryer to confirm that it runs, heats, and shuts off.
instaling your dryer 19
F900A DIKY DVSOF USEIK MANUAL D((_8 03170D EN (_f!fi_j:_ _ ,_ _- _+i i_[_ _) inddK'19// 2013 i 25 9:21x49
I