Table of Contents
Advertisement
11. Fit the lower area of the holder lever in the frame-front hole in the
arrow direction, and push in the holder lever to the end while holding
hook
down the
12. Reattach the screws in the remaining holes.
13. When the holder lever is attached properly, it is supposed to be flexible
in all four directions.
Final installation checklist
•
The dryer is plugged into an electrical outlet and is properly grounded.
•
The exhaust ductwork is hooked up and the joints are taped.
•
A plastic flexible duct is NOT used.
•
Use rigid or stiff-walled flexible metal vent material.
•
The dryer is level and is sitting firmly on the floor.
•
Gas models – the gas is turned on with no gas leaks.
•
Start your dryer to confirm that it runs, heats, and shuts off.
DC68-03380A-10_IB_DV6000H_EN.indd 24
(A).
English - 24
A
2023-06-28
5:44:12
Advertisement
Table of Contents
