GE JBS03 Owner's Manual And Installation Ins page 45

ge, com
Oventemperaturetoo
hot or too colt/
Possible Causes
Oven thermostat
needs adjustment.
What To Do
•
See the Adjust the oven thermostat-Easy to do
yourself] section.
Clock and timer do Plug on range is not completely • Make sure electrical l)lug is l)lugged into a live, ln'Ol)erly
not work inserted in the electrical outlet, grounded outer.
A fuse in your home may be • Replace fl/se or reset drcuit bI'eake_:
blintz or the circuit breaker
tripped.
Oven controls improperly set. • See tile Using the clock and timer section.
Display goes blank A fuse in your home may be • Rel)lace tile fuse or reset the circtfit breaker.
blintz or the circuit breaker
tripped.
The dock is turned off from • See the Using the clock and timersectiou.
showhlg in the displa)_
Oven dooris crooked The door is out of position. • gec;itlse the oven door is removable, it sometimes gets
out of position din'lug installation. To straighten the
door, push down on the high corner.
Oven makes This is the sound of the • This is normal.
clicking noise
heating element turnhag
off and on during
cooking functions.
"F--and a number You have a function error code. • Press the CLEAR/OFFp:_d. Put the oven back
orletter" flash in
into ol)eratiou.
the display If the function code repeats: • L)iscounect all power to the range for at least 30
seconds and then reconnect power./f the ftmction
error code rel)eats, call for service.
• On sell=cleaning models, if a traction error code
al)l)ea_s din'lug the sell=cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, fl'om the locked position. Make sure the latch
ix moved to the right as fhr as it will go. Press the
CLEAR/OFFpad. Allow the oven to cool for one hour.
Put the oven back into operation.
Power outage
Power outage or surge. • Some models will automatically resume their setting once
the power is restored. On models with a clock, you must
xeset the clock. If the oven was in use, you must reset it by
I)ressim"_ the
CLEAR/OFFpad,
,settim,_ the
clock and
resetting any cooking traction.
Displayflashes Power failure.
Unable to get thedisplay Oven control pads were not
to show "SF" pressed properly.
• Reset the clock.
• The
BAKEand BROIL HI/LO
pads m ust be pressed at the
same time and held for 3 seconds.
45
w
_r_ fj_
r_
I
m