Fit Your Smoke Alarm; Test Your Smoke Alarm - Zeta ZD-SI-610/ZD-SO-610 User Manual

3 Fit Your Zeta Smoke Alarm
The alarm will only lock into place in one
particular position. Position the smoke alarm
over the mounting plate lining up the central
vent on the front of the alarm with the 'X'
moulded into the plastic on the mounting plate
and turn clockwise. After one quarter turn you
should feel the alarm click into place.
Once the smoke alarm has been fitted onto
the mounting plate, the internal power pack
will activate. The red LED on the front of
the alarm should now flash once every 40
seconds to show that it is active.
NOTE: On rare occasions the alarm may
sound when the alarm is first fitted. If this
happens, see Troubleshooting on page 22
3 Fit Your Zeta Smoke Alarm
4 Test Your Zeta Smoke Alarm
After fitting the alarm to the base plate, wait
for 5 seconds for the alarm to settle then test
the alarm. See 'Alarm Test' on page 15
9