GE EGR3000 Owner's Manual & Installation Instructions page 28

Care and cleaning of the range.
Z i _ g
dl i
Usea sewing needle or twist-tie
to unclog the small hole h7the
burner head.
Burner Caps and Heads
NOTE: Before removing the burner caps
and heads, remember their size and location.
Replace them in the same location after
cleaning.
Burner caps
I Jfl off when cool. _\'ash burner caps
in hot, soapy water and rinse with clean
water You may scour with a
plastic scom_ing
pad to relnoxe bm'ned-on food pmxicles.
Burner heads
For proper ignition, make sm'e the
small hole in the section that fits oxer the
electrode is kept open. A ,sewim,_ needle
or wire twist-tie works well to tmclo_* it
The slits in the burner heads must be kept clean
at aft times for an even, unhampered flame.
Clogged or di m' bm'ner po_s or electrodes
_ll not allow the bm'ner to operate properly.
An) spill on or arotmd an electrode must
be carefifll) cleaned. Take care to not hit an
electrode with an){hing hard or it could
be damaged.
Y_)u should clean the burner caps and
burner heads routinely, especially alter bad
sI)illox e_, .... which could cloo_ the I° )enings,
in the bm'ner heads, i,ifl offwhen cool.
To remoxe burned-on food, soak the
bm'ner heads in a solution of mild liquid
detergent and hot water fi)r 20-30 minutes.
For inore stubborll stains, use a toothbrush.
After cleaning
Before putting the burner caps and heads
back, shake out excess water and then dry
them thoroughly by setting in a wam_ oven
fi)r 30 minutes.
NOTE: Donotusesteelwoolor scouring powders
todean theburners.
Replacement
Replace bm'ner heads over the ele(trodes
on the cooktop, in the correct locations
according to their size,
Onsome models:
Medium head Small head
and cap andcap
i • -
ii I _ ,._ i i
Large head Extralarge
andcap headand cap
Onsome models:
Medium head Smallhead
and cap andcap
and cap Large ham
and cap
Make sm'e the slot in the bm'ner head is
positioned over the electrode.
Replace the matching size caps onto the
heads.
Make sm'e that the heads and caps are
replaced in the correct locations.
28