GE EGR3000 Owner's Manual & Installation Instructions page 15

Usingthe clock and timer, ge.com
Not all features are on all models.
Makesure the clockis set to the
correct time of
da_
ToSet the Clock
Tile clock must be set to tile correct time
of day fin" tile atmm/atic oven timing
flmctions to work
properly.
Tile time ot day
cmmot be changed during a timed baking
or self=cleaning cycle.
[] Touch and hold tile TIMER/CLOCK pad
until tile display changes.
[] Depending on which model )ou haxe,
you will set the clock by touching
either tile + or - or tile number pads.
Touch tile mm_ber pads tile same way you
read them. For example, to set 12:34, touch
tile number pads I, 2, 3 and 4in that order:
If number pads are not touched within one
minute
afier you touch tile TIMER/CLOCK
pad, tile display reverts to tile original
setting. /t this happens, press and heM the
TIMER/CLOCKpad and reenter tile time
of day:
[] Touch tile START pad until tile time
of day shows in tile display: This enters
tile time and starts tile clock.
To checkthetimeof daywhenthedisplay is
showing otherinformation, s/knply p ressandhold
the TIMER/CLOCK p ad untilthetime/s displayed
Thet/meof dayshowsuntilanother p adis touched
@D@@D@XD
eeeee
The timer is a minute timer onl>
The CLEAR/OFF pad does not affect
the time_
To Set the Timer
The t_Yner does not control ovenoperations.
Themaximum setting on the timer is 9 hours
and 59 minutes.
[]
[]
Touch tile
TIMER/CLOCK
pad.
Touch tile + or - or tile number pads
tmtil tile amount of time Vou want
sho_:s in tile display: Tile maim um
time that can be entered in minutes
is 59. Times more than 59 minutes
should be changed to horns and
minutes. For example, to enter 90
minutes as 1 hour 30 minutes, touch
I,
3 and 0 in that order:
If youmakea m/stake, t ouchthe TIMER/CLOCK
padandbeginagain.
[] Touch tile START pad. After touching
tile STARTpad, SET disappeaxs; this
tells w,u tile time is colmfing down,
although tile display does not change
tmtil one minute has passed.
[] "x_q/en tile timer reaches .'/70, tile
control will beep 3 times follo_ed
by
one beep every 6 seconds tmtil tile
TIMER/CLOCKpad is touched.
The6 second tone can be canceled by following
the steps in the Specialfeatures of your ovencontrol
section under Tonesat the Endof a TimedCycle.
To Reset the Timer
If tile display is still showing tile time
remaining, you may change it by touching
tile TIMER/CLOCK
pad, then touch tile ÷ or
- or tile number pads until tile time you
want appea_s in tile displa>
If tile remaining time is not in tile display
(clock, delay start or cooking time are in
tile display), recall tile remaining time by
touching
tile TIMER/CLOCKpad and then
touching tile
ntlI/lbeI"
pads to enter tile
new tillle Vi)[i W;lIlt,
To Cancel the Timer
Touch tile TIMER/CLOCK pad twice.
Power Outage
If a flashing time is in the display,you have
experienceda power failure, fleset the clock.
To reset tile clock, touch and hold tile
TIMER/CLOCK pad until the display changes.
Enter tile correct
time of day by touching
tile 4 or - or tile appropriate number
pads. Touch
tile START pad.
15