Sony DWRS02D/14 Operating Instructions Manual page 25

Cross Remote condition
indication
Note
If the receiving channel (CH) configured on
the receiver is a channel for which use with
the wireless remote control function is
restricted on the transmitter side, the
UNMATCH screen appears.
In such cases, change the receiving channel
on the receiver. If you want to use the
restricted channel, set REMOTE to OFF in
the transmitter's menu to release the
channel restriction, and manually configure
the transmitter's channel.
On Cross Remote condition
indication
Indicates the signal transmission condition
of the wireless remote control function (4
levels).
: Good transmission
: Somewhat good transmission
: Somewhat poor transmission
: Poor transmission
: Unable to communicate with
paired receiver
When the wireless remote control function
is off, this indication does not appear.
Using the Cross Remote with
a previous pairing
With the TX1/2 menu, select RF REMOTE,
and then select ON.
Notes
• When you set RF REMOTE to ON, the
transmitter will communicate with the
receiver to which it was previously
paired. To use the wireless remote
control function with another transmitter,
you must perform the pairing procedure
again for that transmitter.
• Pairing with multiple transmitters is not
possible.
The following transmitter settings
can be performed through Cross
Remote:
• Group/channel/band setting
• RF transmission power setting
• Audio input attenuation setting
• Low-cut filter setting
• Power save setting
• +48V setting
For details on the transmitter settings, see
"Changing the Settings on the Transmitter" on
page 26.
Cancelling the Cross Remote
In the TX1/2 menu, select RF REMOTE,
and then OFF.
Notes on the Cross Remote
The wireless remote control function on the
receiver uses the 2.4 GHz band and may
thus be subject to interference from other
devices.
• When pairing fails ("Pairing fail" is
displayed), carry out pairing again.
Successful communication between the
transmitter and the receiver has not
occurred within a given amount of time.
Pairing may be harder to do when another
receiver is engaged in pairing nearby.
• When it becomes hard to use the remote
control, the remote control may be
improved by switching the wireless
remote control function off, then on again
in the RF REMOTE display, then re-
pairing with the transmitter (change to a
channel with less interference).
Using the Cross Remote 25