Selecting The Sync Signal (Sync Source); Terminating The Sync Signal (Word Sync 75Ohm); Selecting Output; Output1) - Sony DWRS02D/14 Operating Instructions Manual

Note
The function does not operate for analog
output.
– 36 dBFS LINEAR: The audio signal
from the transmitter is output with a
headroom of 36 dB.
– 20 dBFS LIMITER: The reference level
is changed to –20 dBFS in conformity with
the normal AES/EBU interface and the
audio signal from the transmitter is
compressed.
– 20 dBFS ST LIMIT: The reference level
is changed to –20 dBFS (as in the –20 dBFS
LIMITER mode above) and audio signal
compression is linked for tuner 1 and tuner
2. Select this setting when sending stereo
audio signals using 2 transmitters.
Selecting the Sync Signal
(SYNC SOURCE)
Selects the sync signal source for the
receiver when it is attached through the
optional DWA-01D/F01D wireless adapter.
The receiver supports an external sync
signal (word clock) of 32 kHz –6% to 96
kHz +6%.
For details on locking the sync signal, refer to the
operating instructions supplied with the adapter.
INTERNAL: The internal sync signal (48
kHz) is used.
AUTO: The external sync signal is used on
a priority basis. When there is no external
sync signal input, the internal sync signal is
used automatically. The currently selected
sync signal is displayed "INTERNAL" or
"EXTERNAL."
EXTERNAL: Synchronization with an
external word clock signal. The current
synchronization status is displayed
"UNLOCK" or "LOCK."
Note
When "EXTERNAL" is selected, digital
signals and analog signals will be output
only if there is an external word clock signal
input.
Terminating the Sync
Signal
(WORD SYNC 75ohm)
This function provides termination for the
WORD SYNC connector on the DWA-
01D/F01D wireless adapter.
ON: 75-ohm termination is added.
OFF: 75-ohm termination is not added.
Note
When the receiver is turned off, the
termination is released.

Selecting Output 1

OUTPUT1)

Selects the OUTPUT1 connector of the
DWA-01D/F01D wireless adapter.
When the OUTPUT2 connector of the
adapter is being used for AES/EBU output,
the OUTPUT1 connector can be used for
sub-output.
RX1: Outputs the audio signal received on
tuner 1.
RX2: Outputs the audio signal received on
tuner 2.
RX1+2: Mixes and outputs the audio
signals received on tuners 1 and 2.
Showing the Accumulated
Use Time
(TIME)
You can display the accumulated battery
use time as a rough estimate of total
receiver usage.
The factory setting is "00:00".
(ANALOG
UTILITY Menu 19