Fip1.7 Fip Paper Jam/Regi To Fuser - TallyGenicom 9045N Service Manual

FIP1.7 FIP Paper Jam/Regi to Fuser

Step
Possible causes:
FUSER ASSY (PL8.1.20)
HVPS/MCU (PL12.1.19)
CLUTCH REGI (PL5.1.23)
BTR ASSY (PL8.1.21)
EP CARTRIDGE
GEAR ASSY HOUSING (PL11.1.3)
HARNESS ASSY FUSER (PL8.1.17)
LVPS (PL12.1.5)
150 FEEDER ASSY (PL5.1.1)
GUIDE ASSY CRU R (PL8.1.25)
Checking the paper condition Is the paper in the tray
1
crumpled or damaged?
Checking paper size setup
2 Does the paper size in use match the size setup by
GUIDE ASSY END or by the Driver on the PC?
Checking paper position (1)
Does the front end of paper touch with Actuator Exit in
3
FUSER ASSY? Open COVER OPEN (PL1.1.2) to
check.
Checking paper position (2)
Does the front end of paper go through the Heat Roll /
4
Pressure Roll in FUSER ASSY?
Remove EP CARTRIDGE to check.
Checking paper position (3)
5
Does the front end of paper go through BTR ASSY?
Checking paper position (4)
Does the front end of paper go between ROLL REGI
6
METAL (PL5.1.34) and ROLL REGI RUBBER
(PL5.1.12)?
Checking Actuator Exit for operation
Does Actuator Exit move smoothly, when touching
7 Actuator Exit with a finger inserted from the exit of
FUSER ASSY, and moving it up and down?
Remove EP CARTRIDGE to check.
Checking Exit Sensor for operation (1)
Does the number of Sensor/Switch Check increase,
every time Actuator Exit is pushed and released?
8
Check using Chapter 2 Diagnostic [Sensor /Switch
Check].
Remove EP CARTRIDGE to check.
Checking Exit Sensor for operation (2)
Is the voltage across P/J46-5(+) and P/J46-4(-) on
9 LVPS, 0VDC when Actuator Exit is pushed, and
3.3VDC when released?
Remove EP CARTRIDGE to check.
Check
1 – 17
Chapter 1 Troubleshooting
Yes
Replace the
paper with a new Go to step 2.
and dry one.
Replace the paper,
Go to step 3. or change the
paper size set.
Go to step 7. Go to step 4.
Replace HVPS/
MCU. Go to step 5.
(RRP12.10)
Go to step 15. Go to step 6.
Go to step 14. Go to step 19.
With tool Go to
Replace FUSER
step 8. Without
ASSY. (RRP8.8)
tool Go to step 9
Replace HVPS/
MCU. Go to step 10.
(RRP12.10)
Replace LVPS.
Go to step 10.
(RRP12.3)
No