How To Use Ipconfig - Ericsson HM210DP/DI User Manual

14.4.2

How to use IPCONFIG

This utility is used mainly to view, release and renew you PCs IP address
configuration.
Use IPCONFIG if your PC is running Windows NT, 2000 or XP:
EN/LZT 108 6492 R2 - October 2003
1. From the Start menu select Run... .
2. Type winipcfg and click OK. The "IP Configuration" dialog box
appears.
3. From the scroll down menu at the top, select the network card that
you are using. This is important if you have more than one network
card.
4. Make sure that the Default gateway is the IP address of your
HM210dp/di. If it is not, you will not be able to connect to the
Internet.
If you are using DHCP, click the Release and then the Renew
buttons to receive the correct IP settings.
If you manually set your network settings, make sure that the IP
address of your HM210dp/di is set in the Gateway portion of the
TCP/IP settings in your network settings.
5. Click OK to close the "IP Configuration" dialog box.
1. From the Start menu select Programs > Accessories >
Command Prompt. The "Command Prompt" window appears.
2. Type ipconfig to display your IP configuration.
3. Make sure that the Default gateway is the IP address of your
HM210dp/di. If it is not, you will not be able to connect to the
Internet.
If you are using DHCP, type ipconfig /release and when the C:\>
prompt appears again type ipconfig /renew to receive the correct
IP settings.
4. Close the "Command Prompt" window.
Troubleshooting
107