Table of Contents
Advertisement
3. Normally closed.
4. Motion + N-C.
5. Motion + N-O.
In normally open mode, if the cable between the sensor and the unit is cut
by an intruder, the unit starts recording. In normally closed mode, if the
cable between the sensor and the unit is cut by an intruder, the unit stops
recording.
4.12 How to Operate Motion Detection Recording
Follow the steps given below to activate motion-detection recording.
1.
Please go to the "SENSOR SETUP" menu as shown in the figure.
2.
Select the required motion option.
3.
After the selection, please go back to the MAIN MENU and go to
"PROGRAMMED RECORD" to activate the alarm setting.
Note:
SENSOR RECORD TIME
ALARM OUT TIME
CHANNEL-1 TYPE:MOTION + N-C
CHANNEL-2 TYPE:MOTION + N-O
CHANNEL-3 TYPE:NORMAL
CLOSE
CHANNEL-4 TYPE:NOT
INSTALLED
PRESS (
PRESS(
PROGRAMMED RECORD
+ T T T S S T T T T T T T T T +
0 3 6 9 12 15 18 21 24
PRESS (
PRESS(
Setting "PROGRAMMED RECORD" is neces-
sary for starting the operation of motion detection
recording.
SENSOR SETUP
), THEN ( )
) TO EXIT
), THEN ( )
) TO EXIT
29
15
20
Chapter 4
Advertisement
Table of Contents
