Garmin GLADIATOR TR-1 Installation Setup Manual page 11

Pump Set
ECU
Compass Ball
HH/Remote
Deckmount/On-Off
Battery Cable
Tach Cable
Warning Horn
Shadow Drive
Supply Voltage
In line fuse
Operating Ambient Temperature
You will be hard mounting four components in your boat:1) The pump unit 2) The Deckmount switch 3) The
Compass Ball 4) The Electronic Control Unit (ECU). Other components to install include, Shadow Drive Valve,
Warning Horn, Battery Cable, Tachometer inputs, Handheld and optional is the NMEA (GPS) connections.
Spend some time to figure out where you are going to mount all of the components before you start to mount any
of them. Place components where you expect to mount them and verify you have access to, length, and routes for
the cables and hoses that connect the components. 10, 6, & 3 meter extension cables with the pico connectors
at both ends are available for extending the Handheld, Compass Ball, Deckmount, from TR-1. The Warning
horn and Shadow Drive may be extended using any 18-22 gauge wire. The Tach can be extended at the wire ends
by using shielded twisted pair, the cable end can be extended using a standard pico extension.
• Tools Needed
Some tools will be required for installation of the autopilot. Drill and drill bits, Phillips
screwdriver, end wrenches, wire strippers, pliers, side cutters, hose cutter/pipe cutter, safety
glasses.
Other supplies that may be needed: Hydraulic fluid, rags, Helm/Hydraulic Bleeding Equipment.
Refer to helm bleeding instructions for proper tools required.
• Mounting Screws & Wire Ties
Some mounting screws are provided. You may choose to drill and tap the mounting surface.
Some wire ties are included in the installation kit, but you may need more
depending on application.
TR-1 Gladiator Specifications
10.75" L x 4.625" x 4.75"
6.5" H x 7" W x 2" D
3.6"Diameter
5" x 2.5 x 1"
5/8" x 2.5 "
12 gauge
2-5/8" L X 1-1/4 Dia
11.5-14.0
Preparation For Installation
11
Ignition Protected
Cable Length 20'
Cable Length 20'
Cable Length 10'
Cable Length 8'
Cable Length 13'
Wire Length 9'
Wire Length 9'
VDC
ATO 40 Amp
20 to 120 deg.F