Table of Contents
Advertisement
DIAGRAM OF THE CONSOLE
f
ZONE
TRAWmt_
_O_
CAL/
FAT CAL
TWE/OISTANCE
ulse Sensor --
•
*
__---_
Key
_Speed Control
Note: If there is a thin
sheet of clear plastic
Y'_L_
on the face of the
--
Clip
console, remove it.
Press three batteries into the battery compartment, with
the negative (-) ends of the batteries touching the
springs. Close the battery cover.
Batteries----_
Cover
8"
STEP BY STEP CONSOLE OPERATION
Before operating the console, make sure that the power
cord is properly plugged in. (See HOW TO PLUG IN
THE POWER CORD on page 7.)
The console requires three "AA" batteries (not in-
cluded); alkaline batteries are recommended. Open the
battery cover as shown in the drawing at the upper right.
Next, step onto the foot rails of the treadmill• Find the
clip attached to the key (see the drawing at the top of
this page), and slide the clip onto the waistband of your
clothing.
Followthe steps below and on page 9 to operate the
console.
I]
Insert the key fully into the power switch.
Inserting the key will not
turn on the displays.
The displays will turn on
when the ON/CLEAR
button is pressed or the
walking belt is started.
Note: If you just installed
batteries, the displays will already be on.
Advertisement
Table of Contents
