Configuring Poe; Configuring Poe Properties - Cisco SG200 Series Administration Manual

Port Management

Configuring PoE

STEP 3
Configuring PoE
NOTE
STEP 1
STEP 2
Cisco Small Business SG200 Series 8-port Smart Switch
- Long—Long LACP timeout is 3 times the long periodic timer to transmit
LACP packets. The default Long LACP timeout is 90 seconds.
Click Apply and then click Close. Your changes are saved to the Running
Configuration.
On the SF200E-24P switch, ports 1–6 and 13–18 can operate as Power-over-
Ethernet (PoE) power-sourcing equipment (PSE). PSE ports can provide power to
connected PoE Powered Devices (PD).
On switches with PSE ports, the following topics provide information on the
configuration pages available in the Port Management > PoE menu:
•

Configuring PoE Properties

• Configuring PoE Port Settings
These configuration pages do not display on switches that do not support PSE
functionality.
Configuring PoE Properties
You can use the Properties page to configure whether the switch generates trap
messages under certain conditions and to view current power settings.
To configure PoE properties:
Click Port Management > PoE > Properties in the navigating window.
Set the following parameters:
• Power Trap Threshold—Specify a percentage of total available system
power. When the requested power on PoE ports exceeds the threshold, a
trap is generated to the log.
4
96