Administration
File Management
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business SG200 Series 8-port Smart Switch
To upgrade or backup the firmware or to update the boot code or language file:
Click Administration > File Management > Upgrade/Backup Firmware/
Language in the navigation window.
Enter the parameters:
•
Transfer Method—Select the protocol to be used for the file transfer (TFTP
or HTTP), which corresponds to the type of server you are downloading to
or uploading from.
•
Save Action—Select Upgrade to download a file to the switch, or select
Backup to copy a file from the switch to the server.
•
File Type—Select the type of file to upgrade or back up (you can back up
only the firmware image):
-
Firmware Image—Controls all switch features and interfaces.
-
Boot Code—Controls the initial system bootup.
-
Language File—Strings used by the system interface to display the
selected language.
•
TFTP Server (TFTP only)—Specify the IPv4 or IPv6 address of the TFTP
server. Or specify the server name if DNS is enabled in the IP configuration
(see Domain Name System).
•
Source File Name—For upgrades via TFTP, enter the filename, including the
path. For upgrades via HTTP, browse and select the file from your computer.
•
Destination File Name—For backups via TFTP, enter the filename, including
the path. This field does not appear for backups via HTTP.
Click Apply to begin the upgrade or backup. A progress bar indicates the status of
the file transfer. A typical image transfer might take 5-6 minutes to complete.
Reboot the switch to use the new configuration or firmware.
3
57