Table of Contents
Advertisement
Your StreetPilot is designed to be portable, allowing you to easily transport the unit from vehicle
to vehicle or take it with you once you reach your destination. A Dash Mount Kit consisting of a
mounting bracket, mounting base, required hardware and adhesive pads is included in the StreetPilot
package. This provides a semi-permanent method of installing the unit at the best viewing location for
the driver or passenger(s). The dash mount bracket may be either permanently or temporarily
mounted using the included adhesive materials. Follow instructions for installing the mounting
bracket on the StreetPilot as explained in the instruction sheet provided with the Dash Mount Kit
which also includes specific instructions for installation of all kit components. General instructions are
included here for your convenience.
Carefully choose the placement
of the base on the dash and
install using either the temporary
or permanent adhesive.
To install the cigarette lighter adapter, locate the connector on the rear of the StreetPilot unit
(behind the rubber weather cap). The connector is "keyed" with a notch located between two pins.
Mate the plug on the cigarette lighter adapter to this connector by aligning the notches and pushing
the plug into the connector until fully seated (picture at right). Use care when routing the adapter
cable being certain that it does not interfere with vehicle operation in any way.
Slide the locking lever to the right to lock
Slide the StreetPilot and
the unit, preventing it from sliding off
mounting bracket into the
the base.
base until it snaps into
place.
Quick-Start
Dash Mounting and
External Power Connection
To remove the unit from the base, slide the
lever to the left, depress
the release tab, slide the unit to
the right, and lift from the base.
Rubber
Weather
Cap
Cigarette
Lighter
Adapter
5
Advertisement
Table of Contents
