Yealink SIP-T22P Installation Manual
Yealink SIP-T22P Installation Manual

Yealink SIP-T22P Installation Manual

Enterprise ip phone
Hide thumbs Also See for SIP-T22P:

Advertisement

1. Press the
key when the phone is idle to get the IP address of your phone.
2. Open the web browser of your computer, enter the IP address into the address bar (e.g.
"http://192.168.0.10" or "192.168.0.10") and click
3. Enter the user name (default: admin) and password (default: admin) in the pop-up dialogue
box and click
.
Please locate your computer in the same network segment of the IP phone (192.168.0.X) to access the
web user interface. Contact your system administrator for more information.
Click on
->
You can configure the network settings in the following ways:
: By default, the phone attempts to contact a DHCP server in your network in order to obtain
its valid network settings, e.g. IP address, subnet mask, gateway, DNS server.
: If your phone can not contact a DHCP server for any reason, you need to
configure IP address, subnet mask, gateway, primary DNS and secondary DNS
for the phone manually.
: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Contact the ITSP for the account and password.
The wrong network settings may result in inaccessibility of your phone and may have an impact on the
network performance. Contact your system administrator for more information.
Click on
->
It shows the register status of the current account.
Register Status:
You can select On/Off to enable/disable the account.
Account Active:
It is shown on the LCD to identify the account.
Label:
It is shown as Caller ID when placing a call.
Display Name:
It is provided by ITSP for registration (required).
User Name:
It is authenticated ID for authentication provided by ITSP (required).
Register Name:
It is provided by ITSP for registration (required).
Password:
SIP Server:
It is provided by ITSP for registration (required).
Registered
Register Failed
Check with your system administrator if any error appears during the registration process or if a specific
configuration is required for your registration.
Press the
soft key when the phone is idle, select
Press the
soft key when the phone is idle, select
to configure the account settings.
Contact your system administrator for the password for
Refer to
For more information, refer to the User Guide available online at:
c
Copyright
2012 YEALINK NETWORK TECHNOLOGY CO.,LTD.
.
(X=1,2,3)
Registering
->
->
to configure the network settings.
->
->
.
for the parameter informantion.
->
www.yealink.com
Applies to firmware version 70 or later.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SIP-T22P and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Yealink SIP-T22P

  • Page 1 Contact your system administrator for the password for Refer to for the parameter informantion. www.yealink.com Applies to firmware version 70 or later. For more information, refer to the User Guide available online at: Copyright 2012 YEALINK NETWORK TECHNOLOGY CO.,LTD.
  • Page 2 Please wait ... After that, you can begin to configure the phone via web user interface or phone user interfafce. The headset should be purchased separately. www.yealink.com SIP-T22P Quick Installation Guide...

Table of Contents