IMPORTANT SAFETY INFORMATION.
READALLINSTRUCTIONS BEFORE USING.
a, WARNING!
L.P. C ONVERSION
Your range is shipped from the factory set to operate only with Natural Gas. If you wish to use your
range with Liquefied Petroleum Gas, have the installer check the Installation Instructions that came
with your range.
WARNING: These adjusunents
must be
made by a qualified
seiMce mchnician
ill
accordance
wifll tile
manul_acturer's
instructions
and all codes and requirements
of tile authority
having jurisdiction.
Failure
to follow these instructions
could
result ill serious
iI_ury or property
damage.
Tile qualified
agen W performing
this work
assumes responsibility
tbr tile comersion.
FLOORING UNDER THE RANGE
Your range, like so many other household items, is heavy and can settle into soft floor coverings such
as cushioned vinyl or carpeting.
When
moving
tile range on dlis type of
flooring,
it should be installed
on a 1/4"
thick sheet of plywood
(or similar mamrial)
as follows: When the floor covering ends at the
frontofthe range, tile area that tile rang_ will
rest on should
be buih up with pl_wood
to
tile same level or higher
than the floor
cox_ring.
This will allow tile rang_ to be
moved for cleaning
or servicing.
LEVELING T HE RANGE
[]
Use a 1N" open-end
or adfllsmble
wrench
to equally back out file four legs.
Tile flanges
(rims) below tile sides of tile
cooktop
must be raised abox> tile top of
tile counmrtop.
Carefldly
slide tile rang>
into its installation
space. Obser\>
that it
is clearing
tile counmrtop.
[]
Place a spirit le_l
or a glass measuring
cup partially filled wid_ water on one of
tile oven shelves to check for lexelness.
If using a spirit lexel, take two readings,
with tile level placed
diagonally
first in
one direction
and fllen tile other
[]
AdJust tile four leg_ carefully. Lexel tile
range front to back and side to side. Tile
range legs llltlst rest oil tile floor Tile
rang_ must not hang flom file countertop.
Readand follow this SafetyInformationcarefully.
SAVETHESEINSTRUCTIONS
Q,
Need help?
Do you have a question about the JGSP22 and is the answer not in the manual?