Universal Garage Door Opener (Homelink ) - Jeep 2014 Cherokee User Manual

Hide thumbs Also See for 2014 Cherokee:
Table of Contents

Advertisement

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink
replaces up to three hand-
®
held transmitters that operate devices
such as garage door openers, motor-
ized gates, lighting or home security
systems. The HomeLink
ered by your vehicles 12 Volt battery.
• The HomeLink
buttons that are located
®
in the overhead console or sunvisor des-
ignate the three different HomeLink
channels.
• The HomeLink
®
above the center button.
Before You Begin Programming HomeLink®
• Ensure that your vehicle is parked outside of the garage before you begin
programming.
• For efficient programming and accurate transmission of the radio-frequency
signal, it is recommended that a new battery be placed in the hand-held
transmitter of the device that is being programmed to the HomeLink
• Erase all channels before you begin programming. To erase the channels, place
the ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink
buttons (I and III) for up to 20 seconds or until the red indicator
®
flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
the first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–3515
or, on the Internet at www.HomeLink.com for information or assistance.
Programming A Rolling Code
• For programming Garage Door Openers that were manufactured after 1995. These
Garage Door Openers can be identified by the "LEARN" or "TRAIN" button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
®
unit is pow-
indicator is located
ELECTRONICS
®
®
system.
indicator light in view.
®
for
®
®
113

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents