Jeep 2014 Cherokee User Manual page 116

ELECTRONICS
3. Simultaneously press and hold both the HomeLink
and the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink
indicator will flash slowly and then rapidly after HomeLink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
5. At the garage door opener motor (in the garage), locate the "LEARN" or
"TRAINING" button. This can usually be found where the hanging antenna wire
is attached to the garage door opener motor. Firmly press and release the
"LEARN" or "TRAINING" button.
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has
been pressed.
6. Return to the vehicle and press the programmed HomeLink
(holding the button for two seconds each time). If the device is plugged in and
activates, programming is complete.
NOTE:
If the device does not activate, press the button a third time (for two seconds) to
complete the training.
7. To program the remaining two HomeLink
remaining button. DO NOT erase the channels.
Programming A Non-Rolling Code
• For programming Garage Door Openers manufactured before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
3. Simultaneously press and hold both the HomeLink
and the hand-held transmitter button.
4. Continue to hold both buttons and observe the indicator light. The HomeLink
indicator will flash slowly and then rapidly after HomeLink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
5. Press and hold the programmed HomeLink
light.
NOTE:
• If the indicator light stays on constantly, programming is complete and the garage
door (or device) should activate when the HomeLink
• To program the two remaining HomeLink
remaining button. DO NOT erase the channels.
114
® button you want to program
® buttons, repeat each step for each
indicator light in view.
®
® button you want to program
® button and observe the indicator
® button is pressed.
® buttons, repeat each step for each
®
® has received the
® button twice
®
®
has received the
®